Bimetal bearing strip bonding testing system
Industry: Auto and Ancillary
Customer Requirements
- Setting time for operating is less and operating person interference is minimal.
- Accuracy rate increases
- It’s easier to measure the difference in testing
NV GEN Solution
- NV GEN offered the solution with the testing system for the bimetal – Brass and MS (motel metal)
- The Bearing strip size as per customer required was 80m length and 10m wide
- The system works as the the strip is placed and twisted at a certain angle at a n number of cycle and checked if the center is been opened or not the opening should not me more than the 10mm
- And the system achieved the testing with accurate success
Success Factor
- SCADA based system
- With our solution is became time saving for testing the bearing strip
As it was quite difficult to do the testing with the manpower as more force is required and the accuracy rate is low
Customer Value
- Customer requires testing of the Bimetal bearing strip.
- The strip should be twisted in the n number of cycle and the checked as per the desire parameters